Search Results

Securing electrical cables

Electrical cables should be secured to prevent them hanging. This prevents workers from hitting the low hanging cable....

Crane Signal Person

When hoisting loads to a roof, provide a trained crane signal person. There are 19 official crane signals and the employer must have documentation th...

Warning Line System for Flat Roofing

Roofers can use a warning line system on flat roofs. This requires putting the safety flags at least six feet back. A safety monitor must be designate...

Scaffold Stair Tower

Setting up a scaffold stair tower allows workers to easily access the levels of a multi-story building. It is much safer than having workers climb lad...

Mortar Mixer Guard

Mortar Mixers must be guarded to prevent workers from getting caught by the rotating mixer blades. When the guard is flipped up to clean. the mixer m...

Roofing Debris Chute

Roofing debris chutes are required at 20 feet. A good chute will have guardrail protection so that the worker is protected from falling off the edge....

Concrete form with guardrails

Concrete forms come with the ability to up full guardrails and toeboards to prevent falls....

Checking outlet with GFCI Tester

After a Ground fault circuit interrupter (GFCI) outlet is wired, a tester is used to check that is was wired correctly. Many companies check these on...

Do Not Operate Tag

Whenever a worker discovers equipment that is unsafe, they should place a Do Not Operate tag on it to warn of others of the dangers....

Lockout of service disconnect

When working on electrical circuits that could become energized, a worker must lock out the circuits as shown and then verify the circuits are de-ener...