Silica

| |
CPWR - The Center for Construction Research and Training

Summary Statement

This toolbox talk was created by NIOSH and CPWR and covers the potential hazards created by silica. The design allows workers to view a graphic while the facilitator presents the information. After the talk, the sheet can be posted on the jobsite with the graphic side out to reinforce the key points.
2013

CPWR Toolbox Talk logoSilica is found in many materials common on construction sites, including sand, concrete, rock, mortar, and brick. When workers cut, grind, abrasive blast, jackhammer or perform other tasks that disturb these materials, dust containing crystalline silica can be released into the air. Workers who inhale this dust are at risk. Silica can cause serious, sometimes fatal illnesses including a lung disease called silicosis, lung cancer, and chronic obstructive pulmonary disease (COPD). It has also been linked to other illnesses such as kidney disease.

Here is an Example

Frank has worked as a laborer for 22 years dry cutting, jackhammering and drilling concrete. Water or vacuums were not used to control the dust, and he rarely was provided with a respirator. He began to experience shortness of breath, wheezing, and tiredness after even short periods of work. After a coworker developed tuberculosis, the state health department required all the workers to obtain a chest x-ray. Frank told his doctor about his work history. The doctor had Frank’s x-ray read by a certified class “B” reader because of the possible silica exposure. The results helped in diagnosing his silicosis.

  1. Have you ever been exposed to silica dust either because of the work you were performing or work going on nearby?
  2. How frequently is equipment with water or vacuums attached used to control dust at your worksite?
  3. Have you known anyone who has developed a silica-related health problem?

Preventing Health Problems from Silica

  • Use vacuums or water to reduce or eliminate the dust at the source, before it becomes airborne. When these controls are not enough, use respiratory protection. Routinely maintain dust control systems to keep them in good working order.
  • Do not use sand or other substances containing more than 1% crystalline silica as abrasive blasting materials. Substitute less hazardous materials.
  • Wear disposable or washable work clothes and shower if facilities are available. Vacuum the dust from your clothes and change into clean clothing before leaving the work site. Do not brush or blow the dust off! Do not bring dust home!
  • Avoid eating, drinking and smoking in areas where silica dust is present. Wash your hands and face outside of dusty areas before performing any of these activities.
  • To learn more visit: http://www.silica-safe.org/

What Are We Going to Do Today?

What will we do here at the worksite today to control the dust and prevent exposure to silica dust?

1.____________________________________________________________

_____________________________________________________________

_____________________________________________________________

2.____________________________________________________________

_____________________________________________________________

_____________________________________________________________

OSHA REGULATIONS: 1926 Subpart C 1926.20; .21; .25;.27;.28; Subpart D 1926.51; .55;.57; .59; 1926 Subpart E 1926.95; .103

Graphic of an aerial lift with outriggers and traffic cones.  A worker is standing in the elevated bucket on the lift.

  • Use vacuums or water to reduce or eliminate the dust at the source, before it becomes airborne.
  • Vacuum the dust from your clothes and change into clean clothing before leaving the work site. Do not brush or blow the dust off! Do not bring dust home!